Kohler MPAC 1500 — Module Uninstall Procedure
Maintenance · Accessory I/O modules
For the Kohler MPAC 1500, from the Kohler service manual.
Browse Kohler generators & specs →
Procedure
- If the ATS display shows Module Status Change, press the button labelled Reset.
- If the display shows Check Module Setup to Clear Fault, press Main to return to the main screen.
- Press Set to enter setup mode and enter the setup password.
- Press the down arrow to step to the Set Inputs/Outputs screen, then navigate to Set Auxiliary I/O.
- Press the right arrow to see module 1 status; press the down arrow to step to the next module until Status: Lost is shown.
- Press the right arrow to move to the Uninstall Module screen; verify Uninstall Module Yes (toggle no/yes if necessary).
- Press Save to uninstall the module; repeat for additional modules if necessary.
Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.