Kohler K361 — Static Ignition Timing
Adjustments · Breaker points / flywheel timing marks
For the Kohler K361, from the Kohler service manual.
Browse Kohler generators & specs →
Procedure
- Disconnect spark plug lead from ignition coil; remove breaker point cover.
- Rotate engine by hand clockwise (viewed from flywheel end) until S mark is centered in timing sight hole.
- Points should just begin to break at the S mark; check with ohmmeter or continuity tester.
- Continue rotating engine until points reach maximum opening.
- Measure gap with feeler gauge; gap should be .020 in. fully open.
- Loosen point gap adjustment screw and readjust to .020 in. full open; tighten screw securely.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Breaker point gap .020 in. fully open
- S mark = spark point 20 degrees before top dead center
Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.