Kohler K361 — Engine Shutdown Control Test
Testing & diagnosis · Shutdown control solenoid
For the Kohler K361, from the Kohler service manual.
Browse Kohler generators & specs →
Procedure
- Loosen main fuel adjusting screw and shift bracket holding control from carburetor body.
- Do not disconnect the lead wire from the ignition coil.
- Pull the shutdown control (solenoid and plunger) out of the carburetor.
- Ground the case of the solenoid on the carburetor or convenient engine surface.
- Hold plunger approximately 1/4 in. in front of solenoid, turn ignition switch ON and release plunger.
- If plunger is drawn into solenoid, control is functioning properly; if not, replace solenoid.
Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.