Kohler — Install Flywheel
Installation · Flywheel/Ignition
From a Kohler service manual covering: 1P14 690 11, XTX650, XTX675, XTX775. Check it applies to your exact model before use.
Browse Kohler generators & specs →
Before you start
- Damaging Crankshaft and Flywheel can cause personal injury. Using improper procedures can lead to broken fragments.
- Do not use any type of bar or wedge to prevent flywheel from rotating
Procedure
- Install key into crankshaft keyway. Make sure key is fully seated.
- Install flywheel onto crankshaft aligning keyway with key.
- Align teardrop slot on fan with raised teardrop on flywheel. Align drive cup on flywheel, install and hand tighten nut.
- Using a flywheel strap wrench, hold flywheel still while tightening nut to 51.5 N·m (38 ft. lb.).
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Flywheel retaining nut torque 51.5 N·m (38 ft. lb.)
Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.