Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Half-pulley - Reassembly

Kohler KD626-3 — Half-pulley - Reassembly

For the Kohler KD626-3.

Browse Kohler generators & specs →

Before you start

  • The three stop nuts of the half-pulley should never be tightened simultaneously.

Procedure

  1. 1. The three stop nuts of the half-pulley should never be tightened simultaneously.
  2. 2. Turn the pulley so that whenever you tighten a nut, this is in the position indicated A.
  3. 3. Tightening should be carried out gradually.
  4. 4. The half-pulley fastening nuts must be tightened using the torque wrench to a final torque of 10 Nm.

Specs & torque values

  • Tightening torque: 10 Nm

Source: manual:ED0053029350_R01_MO_KD_626_3_GB.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.