Kohler GM22703-KP1 / GM22703-KP3 — Install padlock bracket on enclosure door (GM22703-KP1 kit for welded enclosures only)
Installation · Enclosure door latch / padlock bracket
For the Kohler GM22703-KP1 / GM22703-KP3, from the Kohler service manual.
Browse Kohler generators & specs →
Procedure
- Remove the existing enclosure door latch on the enclosure door (welded enclosure). Save for reuse.
- Place the padlock bracket (GM57166) and enclosure latch gasket on the enclosure door latch.
- Place the door latch assembly in the hole of the door.
- Position the padlock bracket with the padlock holes horizontal. Install and tighten the mounting nut.
- Verify that the enclosure door latch locks and unlocks the enclosure door. Adjust the hardware as necessary.
Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.