Kohler Ford LSG-423 — Governor Throttle Control Rod Adjustment
Adjustments · Mechanical Governor
For the Kohler Ford LSG-423, from the Kohler service manual.
Browse Kohler generators & specs →
Before you start
- Be sure the throttle control rod is properly installed with the long end at the governor to prevent binding on the ignition wires
Procedure
- Manually move the governor throttle lever to the maximum open throttle with spring tension on the governor
- Check the gap between the carburetor throttle shaft lever and its maximum open position stop; it should be 1/32 to 1/16 inch wide
- If adjustment is necessary, loosen the control rod ball joint lock nuts, remove the rod from the carburetor throttle lever and adjust the length of the rod with the ball joints
- Install the throttle control rod on the carburetor throttle lever and recheck the gap; tighten the lock nuts
Specs & values
- Throttle shaft lever gap 1/32 to 1/16 inch
Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.