Kohler — REMOVE CYLINDER HEAD

A Kohler service procedure — check it applies to your exact model before use.

Browse Kohler generators & specs →

Procedure

1. 1. Remove the hex flange screws, spacer (from the
2. screw by the exhaust port), cylinder head, push
3. rods, and cylinder head gasket. See Figures 9-23
4. and 9-24.
5. 2. Remove the hex flange screw, breather reed re-
6. tainer, and breather reed.
7. 3. Remove the rocker shaft (from the breather side of
8. head), and rocker arms.
9. 4. Remove the valves:
10. 5. Remove the two hex cap screws and rocker
11. bridge.

Source: manual:Kohler_Command_Series_Serv_Man.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.