Kohler — REMOVE IGNITION MODULE

A Kohler service procedure — check it applies to your exact model before use.

Browse Kohler generators & specs →

Procedure

1. 1. Disconnect the kill lead from the ignition module
2. terminal. See Figure 9-21.
3. 2. Rotate flywheel magnet away from ignition mod-
4. ule.
5. 3. Remove the two hex flange screws and ignition
6. module.

Source: manual:Kohler_Command_Series_Serv_Man.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.