Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›REMOVE CONNECTING RODS

Kohler — REMOVE CONNECTING RODS

A Kohler service procedure — check it applies to your exact model before use.

Browse Kohler generators & specs →

Procedure

  1. 1. With a marking pen or paint, mark the connecting
  2. Tods and rod caps as #1 side and #2 side. On
  3. M18 mark which side is top.
  4. 2. Remove the hex. nuts, connecting rod caps, and
  5. connecting rods from crankshaft. Refer to
  6. Figure 9-35.

Specs & torque values

  • 1
  • 2

Source: manual:Magnum_M18_and_M20_Service_Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.