Kohler Workman HDX Auto — Service Procedure

For the Kohler Workman HDX Auto.

Procedure

Bed safety support
Cylinder barrel
Bed

Tools required

Use of an offset wrench (e.g. crowfoot wrench) will affect
torque wrench length. When using a torque wrench with
Recommended fastener torque values are listed in the
Using a Torque Wrench with an Offset Wrench
into aluminum or brass. The specific torque value
dation by the calculated torque conversion factor (Fig.
Torque Specifications
These Torque Specifications for the installation and
torque wrench calibration due to the effective change of
As noted in the following tables, torque values should be
by Toro, either the recommended torque or a torque that
Standard Torque for Dry, Zinc Plated and Steel
Measure the torque required to tighten the fastener until
on the fastener, presence of a prevailing torque feature
TORQUE SPECIFICATIONS
an offset wrench, multiply the listed torque recommen-
Other Torque Specifications
the similar stress as a dry fastener. Torque values may
The standard method of verifying torque shall be per-

Source: manual:15217SL.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.