Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›the kill lead to the crankcase. Remove the four

Kohler — the kill lead to the crankcase. Remove the four

A Kohler service procedure — check it applies to your exact model before use.

Browse Kohler generators & specs →

Before you start

  • NOTE: The intake hydraulic lifter is farthest from
  • NOTE: Insert the screwdriver only in the splitting

Procedure

  1. 2. Locate the splitting notches in the seam of the
  2. closure plate and crankcase. See Figure 9~34. Pry
  3. the closure plate from the crankcase using a large
  4. flat-blade screwdriver.
  5. Kill Leada
  6. e
  7. :
  8. .
  9. *
  10. Hex Flange Screw & Clip’
  11. i
  12. Figure 9-32. Removing Stator.
  13. 1. Remove the twelve hex flange screws securing
  14. the closure plate to the crankcase. S
  15. ee Figure
  16. 9-33.
  17. Closure Plate
  18. Figure 9-33. Removing Closure Plate.
  19. Figure 9-34. Splitting Notch of Closure Plate/
  20. Crankcase.
  21. NOTE: Insert the screwdriver only in the splitting
  22. notches. Do not pry on the gasket surfaces of
  23. the closure plate or crankcase as this can
  24. cause leaks.
  25. 1. Remove the oil seal from the closure plate. See

Tools required

  • 3. Remove the hex socket screw, oil pressure relief

Source: manual:Kohler_Command_Series_Serv_Man.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.