Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›ELECTRICAL SYSTEM AND COMPONENTS

Kohler — ELECTRICAL SYSTEM AND COMPONENTS

A Kohler service procedure — check it applies to your exact model before use.

Browse Kohler generators & specs →

Before you start

  • 4. Note that the cross section of the brush spring is
  • NOTE: Always use a new retainer. Tighten the

Procedure

  1. 6. Replace the brush holder in the frame and place
  2. the brushes in the brush holder. Reinstall the
  3. springs.
  4. Trimmed edge
  5. Spare brush Snap ring
  6. Rear stop collar
  7. Plate i
  8. Crimp
  9. Figure 8-31. Connecting Replacement Brushes.
  10. dering I
  11. Soldering fron Figure 8-33. Installing Snap Ring.
  12. Starter Service
  13. Clean drive lever and armature shaft then apply Kohter
  14. electric starter drive lubricant or equivalent to lever
  15. and shaft.
  16. Solder
  17. ° Starter Reassembly | 8|
  18. 1. Inseri the rear stop collar on the armature shaft.
  19. Figure 8-32. Soldering Brush Clips to Posts. Always use new snap ring.
  20. 8.19
  21. 2. Place the retainer in the groove on the armature
  22. shaft.
  23. NOTE: Always use a new retainer. Tighten the
  24. retainer in the groove to secure.
  25. Figure 8-36. Installing the Stop Collar.

Source: manual:Magnum_M18_and_M20_Service_Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.