Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Service Procedure

Kohler — Service Procedure

A Kohler service procedure — check it applies to your exact model before use.

Browse Kohler generators & specs →

Before you start

  • NOTE: The governor gear is held onto the gover-

Procedure

  1. 3. Remove the governor cross shaft oil seal from the
  2. crankcase. See Figure 9~47.
  3. Figure 9-48. Removing Governor Gear.
  4. NOTE: The governor gear is held onto the gover-
  5. nor gear shaft by small molded tabs in the
  6. gear. When the gear is removed from the
  7. shaft these tabs are destroyed. This will
  8. require replacement of the gear; therefore,
  9. remove the gear only if absolutely neces-
  10. sary (such as when reboring, doing major
  11. engine rebuilding, etc.).
  12. 9.12
  13. 1. Manual (retractable) starting is much easier. With-
  14. out ACR, manual starting would be virtually impos-
  15. sible.
  16. 2. Electric start models can use a starter and battery
  17. size that are practical for the applications in which
  18. these engines are used.
  19. 3. ACR eliminates the need for a spark retard/ad-
  20. vance mechanism. A spark retard/advance

Source: manual:Kohler_Command_Series_Serv_Man.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.