Kohler — Figure 9-41. Removing Connecting Rod. 1. Remove the woodruff key from the flywheel taper

A Kohler service procedure — check it applies to your exact model before use.

Browse Kohler generators & specs →

Procedure

1. 2. Remove the crankshaft from the crankcase. See
2. 1. Remove the wrist pin retainer and wrist pin. Sepa-
3. rate the piston from the connecting rod. See Fig-
4. ure 9-42.
5. Crankshaft
6. Piston
7. Wrist Pin
8. Retainer
9. Connecting
10. Rod
11. Figure 9-44. Removing Crankshaft.
12. | REMOVE FLYWHEEL END OIL SEAL
13. Figure 9-42. Removing Piston From Connecting AND BEARING
14. Rod. 1. Remove the oil seal from crankcase.
15. 2. Remove the bearing from the crankcase using
16. 1. Remove the top and center compression rings handle #NU-4747 and bearing remover
17. using a ring expander tool. See Figure 9-43. #KO-1029. See Figure 9-45.
18. 1. Remove the hitch pin and plain washer from gov-
19. ernor cross shaft. See Figure 9-46.
20. 2. Remove the cross shaft and plain washer from the

Source: manual:Kohler_Command_Series_Serv_Man.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.