Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›the kill lead to the crankcase. Remove the four

Kohler — the kill lead to the crankcase. Remove the four

A Kohler service procedure — check it applies to your exact model before use.

Browse Kohler generators & specs →

Before you start

  • NOTE: The intake hydraulic lifter is farthest from
  • NOTE: Insert the screwdriver only in the splitting

Procedure

  1. 2. Locate the splitting notches in the seam of the
  2. closure plate and crankcase. See Figure 9~34. Pry
  3. the closure plate from the crankcase using a large
  4. flat-blade screwdriver.
  5. Kill Leada
  6. e
  7. :
  8. .
  9. *
  10. Hex Flange Screw & Clip’
  11. i
  12. Figure 9-32. Removing Stator.
  13. 1. Remove the twelve hex flange screws securing
  14. the closure plate to the crankcase. S
  15. ee Figure
  16. 9-33.
  17. Closure Plate
  18. Figure 9-33. Removing Closure Plate.
  19. Figure 9-34. Splitting Notch of Closure Plate/
  20. Crankcase.

Tools required

  • 3. Remove the hex socket screw, oil pressure relief

Source: manual:Kohler_Command_Series_Serv_Man.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.