Kohler — REMOVE VALVE COVER

A Kohler service procedure — check it applies to your exact model before use.

Browse Kohler generators & specs →

Procedure

1. 1. Remove the five hex flange valve cover screws
2. and valve cover from the cylinder head assembly.
3. See Figure 9-18.
4. NOTE: The valve cover is sealed to the cylinder head
5. using RTV silcone sealant. When removing
6. valve cover, use care not to damage the gas-
7. ket surfaces of cover and cylinder head.
8. Figure 9-18. Removing Valve Cover.
9. 1. Remove the hex flange screws securing the cylin-
10. der head baffle to the cylinder head. See Figure
11. 9-19. Remove the baffle.
12. Figure 9-19. Removing Cylinder Head Baffle.
13. 1. Remove the hex flange screws from blower hous-
14. ing and baffles. Disconnect wire hamess from the
15. key switch, if equipped. Remove the blower hous-
16. ing and baffles.
17. Figure 9-20. Removing Blower Housing and
18. Baffles.
19. 1. Disconnect the kill lead from the ignition module
20. terminal. See Figure 9-21.

Source: manual:Kohler_Command_Series_Serv_Man.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.