Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Service Procedure

Kohler — Service Procedure

A Kohler service procedure — check it applies to your exact model before use.

Browse Kohler generators & specs →

Before you start

  • A WARNING: ignition Magnet is Not

Procedure

  1. 2. Remove the filter, seal, breather plate, and gasket.
  2. Refer to Figure 9-13,
  3. 9.4
  4. 1. Remove the hex. nut, copper washer, valve cover,
  5. and gasket. Refer to Figure 9-12.
  6. 1. Remove the truss head screws, fuel pump, and
  7. gasket. Refer to Figure 9-14.
  8. Fuel Pump
  9. Truss Head g
  10. Screws
  11. theese, a
  12. Figure 9-14. Removing Fuel Pump.
  13. 1. Remove the hex. flange screws and ignition mod-
  14. ule. Refer to Figure 9-15.
  15. e Hex Flange
  16. Screws
  17. Figure $-15. Removing [gnitlon Module.
  18. 2. Remove the hex. flange screws and bracket from
  19. #1 cylinder barrel. Refer ta Figure 9-16,
  20. ae

Tools required

  • Figure 9-18. Removing Flywheel Using A Puller.
  • 2. Hold the flywheel with the strap wrench and loos-
  • Strap Wrench

Specs & torque values

  • 1

Source: manual:Magnum_M18_and_M20_Service_Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.