Kohler — ECU Reset Procedure

Testing & diagnosis · Electronic Control Unit (ECU)

From a Kohler service manual covering: 32690-12, EKT730, EKT740, EKT745, EKT750. Check it applies to your exact model before use.

Browse Kohler generators & specs →

Procedure

1. Turn key/ignition OFF.
2. Install Red wire jumper from Kohler EFI service kit onto service port.
3. Turn key ON, then OFF; count 10 seconds.
4. Turn key ON, then OFF; count 10 seconds a second time.
5. Remove Red wire jumper.
6. Turn key ON, then OFF; count 10 seconds a third time.
7. ECU is reset.
8. A TPS Learn Procedure must be performed after ECU Reset.

Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Kohler repair guides →