Kohler — Changing Engine Oil and Oil Filter
Maintenance · Lubrication system
From a Kohler service manual covering: LH630, LH685, LH750, LH760. Check it applies to your exact model before use.
Browse Kohler generators & specs →
Before you start
- Do not overfill or operate below L mark.
Procedure
- Run engine until warm.
- Clean area around oil fill cap and dipstick.
- Remove oil drain plug and dipstick; allow complete drainage.
- Clean area around oil filter and remove old filter.
- Reinstall drain plug; torque to 13.6 N·m (10 ft. lb.).
- Pre-fill new oil filter; lubricate rubber gasket.
- Install new oil filter; turn until gasket contacts, then 2/3-1 turn.
- Fill crankcase to F mark with proper oil.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Oil drain plug 13.6 N·m (10 ft. lb.)
- Oil filter 10.4-12.7 N·m (90-110 in. lb.)
Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.