Kohler — Change Oil and Oil Filter
Maintenance · Lubrication system
From a Kohler service manual covering: 14690-12, CV173, CV200, CV224. Check it applies to your exact model before use.
Browse Kohler generators & specs →
Before you start
- Disconnect spark plug lead(s) before servicing.
Procedure
- Change oil while engine is warm. Clean area around oil fill cap/dipstick and drain plug.
- Remove drain plug and oil fill cap/dipstick; drain oil into appropriate container.
- Clean area around oil filter; remove clean oil change screw; slowly remove filter; wipe mounting surface.
- Apply thread sealant around three full threads of drain plug; reinstall and torque to 13.6 N·m (120 in. lb.).
- Reinstall clean oil change screw; torque to 14.7 N·m (130 in. lb.).
- Apply thin film of clean oil to rubber gasket on new filter; install per filter instructions.
- Fill crankcase with new oil to top of dipstick indicator.
- Reinstall oil fill cap/dipstick and tighten securely.
- Start engine, check for leaks, stop engine, correct leaks and recheck oil level.
- Dispose of used oil and filter per local ordinances.
Specs & values
- Oil capacity (refill) 0.70 L (24 oz.)
- Oil drain plug 13.6 N·m (120 in. lb.)
- Clean oil change screw 14.7 N·m (130 in. lb.)
Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.