Kohler — Change Engine Oil and Oil Filter
Maintenance · Lubricating Oil System
From a Kohler operator's manual covering: KG6208, KG6208TAHD, KG6208TASD. Check it applies to your exact model before use.
Browse Kohler generators & specs →
Before you start
- Dispose of used oil and filters per local environmental regulations
Procedure
- Stop the engine and allow it to cool
- Place a drop cloth and collection container beneath the oil drain valve
- Open the oil drain valve and drain the oil into the container
- Remove the old oil filter with an oil filter wrench
- Wipe the filter installation surface clean and inspect for damage
- Apply a thin film of fresh oil to the new filter gasket
- Screw in the new filter by hand until resistance, then tighten an additional 3/4 turn
- Close the oil drain valve
- Add fresh oil through the oil fill cap
- Check the oil level is between Full and Add marks
- Install and tighten the oil fill cap
- Start and run the engine unloaded for about 5 minutes to distribute the oil
Tools required
- Collection container Amazon
- Replacement oil filter Amazon
- Oil filter wrench Amazon
- Clean, dry cloth Amazon
- Drop cloth Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- 6.0 qt. (5.7 L) dry fill capacity
Source: Kohler operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.