Kohler — Arc Chute Replacement Procedure
Repair & overhaul
From a Kohler service manual — check it applies to your exact model before use.
Browse Kohler generators & specs →
Before you start
- Rubber insulating gloves class 0, safety glasses, and electrical hazard safety shoes required.
Procedure
- Prevent all connected generator sets from starting and disconnect power to the transfer switch.
- Open the enclosure and verify zero volts across each phase.
- Remove the arc chute hold down screws.
- Remove the arc chute and inspect the movable contact for damage.
- Install the new arc chute and holding screws and washers; torque to 2.8 Nm (25 in. lb.).
- Manually operate the switch several times to ensure that it does not stick.
- Close the enclosure, reconnect power, and enable the generator set.
- Test using the Automatic Operation Test Procedure.
Tools required
- Basic electricians hand tools
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Arc chute screws 2.8 Nm (25 in. lb.)
Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.