Kohler — Adjustable Jets (Plastic) Service

A Kohler service procedure — check it applies to your exact model before use.

Browse Kohler generators & specs →

Procedure

1. Using a small screwdriver loosen the ball lock ring.
2. Remove ball and lock ring from jet housing.
3. Using a 9/16 inch socket wrench remove the orifice from the jet housing.
4. Replace parts as required and clean all surfaces before reassembly.
5. Assemble orifice into jet housing.
6. Assemble ball and ball lock ring into jet housing. Tighten with small screwdriver.

Source: manual:OM-SA_100194_0884.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.