Kohler 48RCLB / KG6208 — Change Engine Oil and Oil Filter
Maintenance
For the Kohler 48RCLB / KG6208, from the Kohler operator's manual.
Applies to: Kohler 48RCLB, Kohler KG6208 engine
Before you start
- Accidental starting: disconnect battery cables, negative (–) lead first
- Hot engine and exhaust system: do not work until it cools
Parts for this job
Part numbers from the service-parts list for Kohler 48RCLB. Verify against your serial number before ordering; some links are affiliate links.
Procedure
- Stop the engine and allow it to cool.
- Place a drop cloth and collection container beneath the oil drain valve.
- Open the oil drain valve and allow the oil to drain into the container.
- Using an oil filter wrench, remove the old oil filter.
- Wipe the oil filter installation surface clean and inspect it for damage.
- Apply a thin film of fresh oil to the gasket of the new oil filter.
- Lightly screw in the new oil filter by hand until resistance, then tighten an additional 3/4 turn.
- Close the oil drain valve.
- Add fresh oil through the oil filler cap.
- Check the oil level between the Full and Add marks on the dipstick.
- Install and tighten the oil filler cap.
- Start and run the engine without load for approximately 5 minutes.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Change engine oil and filter every 150 hours
- Tighten oil filter an additional 3/4 turn after resistance
Full service-parts list: Kohler 48RCLB →
Source: Kohler operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.