Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Kohler›Controller Setup Procedure

Kohler 48RCLB / 60RCLA — Controller Setup Procedure

Installation · RDC2 controller

For the Kohler 48RCLB / 60RCLA, from the Kohler service manual.

Applies to: Kohler 48RCLB, Kohler 60RCLA, Kohler KG6208 engine

Procedure

  1. Set parameters using controller buttons/menus or SiteTech software.
  2. Set Genset Model Number (48RCLB or 60RCLA).
  3. Enter Genset Serial Number from the nameplate.
  4. Set Fuel Type (Natural Gas or Liquid Propane).
  5. Set Phase Connection per Figure 3-8.
  6. Set Genset System Voltage from nameplate.
  7. Set Genset System Frequency (50 or 60 Hz).
  8. Check voltage calibration and adjust if necessary.

Tools required

  • Personal computer with SiteTech (optional) Amazon

Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.

Full service-parts list: Kohler 48RCLB →, Kohler 60RCLA →

Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Kohler repair guides →