Home›Repair guides›Kohler›Battery Installation Procedure

Kohler 12RES — Battery Installation Procedure

Installation · Engine starting battery

For the Kohler 12RES, from the Kohler service manual.

Applies to: Kohler 12RES

Before you start

  • Battery electrolyte is a diluted sulfuric acid. Battery acid can cause severe injury or death.
  • Battery short circuits. Explosion can cause severe injury or death.
  • The generator set will not start and circuit board damage may occur if the battery is connected in reverse.

Procedure

  1. Ensure that the starting battery is fully charged before placing the battery in service.
  2. Clean the battery posts and/or adapters if necessary.
  3. Install the battery post adapters, if needed.
  4. Place the battery in the housing.
  5. Verify that the controller master switch is in the OFF position.
  6. Connect the positive (+) lead to the engine starting battery.
  7. Connect the negative (--) lead to the engine starting battery.

Specs & values

Full service-parts list: Kohler 12RES →

Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Kohler repair guides →