John Deere — Torque-Turn Connecting Rod Cap Screws
Repair & overhaul
From a John Deere service manual — check it applies to your exact model before use.
Browse John Deere generators & specs →
Before you start
- Never use new connecting rod cap screws when checking rod bore ID.
- NEVER use connecting rod cap screws more than once for final engine assembly.
- DO NOT use pneumatic wrenches to install connecting rod cap screws.
Procedure
- After tightening cap screws to 75 N-m (55 lb-ft), mark connecting rod cap and socket.
- Position handle of wrench parallel to centerline of engine crankshaft axis.
- Tighten 1/4 turn (90-100°) clockwise until handle of wrench is perpendicular to centerline of engine crankshaft axis.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Initial 27 N-m (20 lb-ft) blind hole cap screw
- All cap screws 75 N-m (55 lb-ft)
- Torque-turn 90-100°
Source: John Deere service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.