John Deere — The following sequence is suggested when complete

A John Deere service procedure — check it applies to your exact model before use.

Browse John Deere generators & specs →

Procedure

1. 1. Drain all coolant and engine oil. Check engine oil
2. 2. Remove carburetor, throttle valve, and pressure
3. 3. Remove turbocharger oil inlet and outlet line and
4. 4. Remove exhaust elbow and connector. Remove
5. 5. Remove auxiliary water pump and brackets (if
6. 6. Remove fan pulley and water manifold assembly.
7. 7. Remove front crankshaft pulley and damper
8. 8. Remove ignition wires and spark plugs.
9. 9. Remove ignition control unit, coils, mounting plate,
10. 10. If equipped, remove electronic governor, throttle
11. 11. Remove water pump.
12. 12. Remove engine oil filter and oil conditioning
13. 13. Remove aftercooler and intake manifold
14. 14. Remove rocker arm cover and breather hose.
15. 15. Remove rocker arm assembly and push rods.
16. 16. Remove cylinder head. Remove head gasket.
17. 17. On SAE No. 3 flywheel housings, remove
18. 18. On SAE No. 1 and 2 flywheel housings, remove
19. 19. Remove oil pan and engine oil pump assembly.
20. 20. Remove front timing gear cover.

Source: manual:CTM82.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.