John Deere — The following sequence is suggested when complete

A John Deere service procedure — check it applies to your exact model before use.

Browse John Deere generators & specs →

Procedure

1. 1. Drain all coolant and engine oil. Check engine oil for metal contaminates.
2. 2. Remove carburetor, throttle valve, and pressure regulator.
3. 3. Remove turbocharger oil inlet and outlet line and coolant inlet and outlet lines.
4. 4. Remove exhaust elbow and connector. Remove turbocharger.
5. 5. Remove auxiliary water pump and brackets (if equipped). Remove alternator and mounting brackets.
6. 6. Remove fan pulley and water manifold assembly.
7. 7. Remove front crankshaft pulley and damper assembly.
8. 8. Remove ignition wires and spark plugs.
9. 9. Remove ignition control unit, coils, mounting plate, and spacer plate. Remove ignition timing sensor and plate.
10. 10. If equipped, remove electronic governor, throttle actuator, speed sensor, and wiring harness.
11. 11. Remove water pump.
12. 12. Remove engine oil filter and oil conditioning housing.
13. 13. Remove aftercooler and intake manifold assembly, and exhaust manifold.

Source: manual:CTM82.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.