John Deere — Removing Engine from Storage
Maintenance
From a John Deere operator's manual covering: 4039, 4045, 6059, 6068, RG4697. Check it applies to your exact model before use.
Applies to: John Deere 4039, John Deere 4045, John Deere 6059, John Deere 6068
Before you start
- Do not operate starter more than 30 seconds at a time. Wait at least 2 minutes for starter to cool before trying again
Procedure
- Remove all protective coverings from engine. Unseal all openings in engine and remove covering from electrical systems.
- Remove the batteries from storage. Install batteries and connect the cables.
- Install new fan and alternator belts. Adjust belt tensions to their appropriate specifications.
- Fill fuel tank.
- Perform all appropriate prestarting checks.
- Crank engine for 20 seconds with starter (do not allow the engine to start). Then start engine.
- Operate engine at slow idle for several minutes. Warm up carefully and check all gauges before placing engine under load.
Full service-parts list: John Deere 4039 →, John Deere 4045 →, John Deere 6068 →
Source: John Deere operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.