Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Identify parts for re-assembly.

John Deere — Identify parts for re-assembly.

A John Deere service procedure — check it applies to your exact model before use.

Browse John Deere generators & specs →

Procedure

  1. 16. Remove cylinder head. Remove head gasket.
  2. 17. On SAE No. 3 flywheel housings, remove flywheel then remove flywheel housing.
  3. 18. On SAE No. 1 and 2 flywheel housings, remove flywheel housing and then remove flywheel.
  4. 19. Remove oil pan and engine oil pump assembly.
  5. 20. Remove front timing gear cover.
  6. 21. Remove pistons and connecting rods. Identify for re-assembly. Perform wear checks with PLASTIGAGE™.

Source: manual:CTM82.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.