John Deere 4045TF150 Engine — Removing and Installing Final Fuel Filter/Water Separator Base
For the John Deere 4045TF150 Engine.
Applies to: John Deere 4045TF150 Engine
Before you start
- F
- u
- e
- l
- l
- i
- n
- e
- s
- m
- a
- y
- b
- e
- c
- o
- n
- n
- e
- c
- t
- e
- d
- t
- o
- d
- i
- f
- f
- e
- r
- e
- n
- t
- f
- i
- l
- t
- e
- r
- i
- n
- l
- e
- t
- a
- n
- d
- o
- u
- t
- l
- e
- t
- p
- o
- r
- t
- s
- d
- e
- p
- e
- n
- d
- i
- n
- g
- o
- n
- e
- n
- g
- i
- n
- e
- a
- p
- p
- l
- i
- c
- a
- t
- i
- o
- n
- .
Procedure
- Thoroughly clean fuel filter/water separator assembly and surrounding area to keep from getting dirt and debris into fuel system.
- Connect a drain line to filter drain adapters and drain all fuel from system.
- Remove final fuel filter base.
- Remove final fuel filter element and water separator if desired.
- Disconnect fuel lines from all ports.
- Remove final fuel filter base.
- Replace parts as necessary.
- Install mounting brackets and tighten to torque specifications.
- Install water separator and fuel filter elements.
- Connect fuel lines to all ports.
- Bleed the fuel system.
Specs & torque values
- Fuel Filter Base Mounting Bracket-to-Cylinder Head Torque: 35 N·m (26 lb-ft)
- Final Fuel Filter Mounting Base-to-Bracket Torque: 35 N·m (26 lb-ft)
Source: manual:CTM284.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.