Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›–UN–14JUN02

John Deere — –UN–14JUN02

A John Deere service procedure — check it applies to your exact model before use.

Browse John Deere generators & specs →

Procedure

  1. 1. If gear has been removed, r
  2. emove oily residues from
  3. pump driveshaft and torque high pressure pump gear
  4. nut (A) to pump driveshaft using specification below.
  5. Specification
  6. High Pressure Pump Gear Nut—
  7. Torque
  8. 68 N•m (50.1 lb-ft)
  9. ..........................................................................
  10. 2. If adapter plate (F) has been removed from high
  11. pressure pump, torque the pump to the adapter plate
  12. using the specification below.
  13. Specification
  14. High Pressure Pump to Adapter
  15. Plate—Torque

Tools required

  • respect to pump, torque adapter plate cap screws to
  • 2. If adapter plate (F) has been removed from high
  • High Pressure Pump to Adapter

Specs & torque values

  • 50.1 lb-ft
  • 6.6 lb-ft
  • 19.9 lb-ft

Source: manual:CTM220.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.