John Deere — Procedure 7

A John Deere service procedure — check it applies to your exact model before use.

Browse John Deere generators & specs →

Procedure

1. 1. Install the fuel transfer pump to cylinder block with
2. pumping lever resting on top of push rod, using a new
3. O-ring. Tighten cap screws (C) to specifications.
4. Specification
5. Fuel Transfer Pump Cap
6. Screws—Torque
7. 30 N•m (22 lb-ft)
8. ..............................................................
9. IMPORTANT: ALWAYS use a backup wrench when
10. installing fittings and/or fuel lines onto
11. supply pump to avoid damage to
12. fittings.
13. 2. Connect supply pump inlet line (A) and outlet line (B)
14. and tighten securely.
15. 3. Bleed fuel system. See BLEED THE FUEL SYSTEM in

Source: manual:CTM220.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.