John Deere — –19–22MAY02–2/2
A John Deere service procedure — check it applies to your exact model before use.
Browse John Deere generators & specs →
Procedure
- 9. Install water bowl and pre-filter element. See
- REPLACE PRE-FILTER ELEMENT later in this Group.
- 10. Connect fuel lines to fuel inlet and fuel outlet and
- tighten to specification.
- Specification
- Pre-filter Fuel Filter Inlet Line—
- Torque
- 9 N•m (6.6 lb-ft)
- ..............................................................................
- Pre-filter Outlet Line—Torque
- 9 N•m (6.6 lb-ft)
- ..........................................
- 11. Bleed the fuel system. See BLEED THE FUEL
- SYSTEM in Section 04, Group 150 later in this
- manual.
Specs & torque values
- 6.6 lb-ft
Source: manual:CTM220.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.