Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›REMOVE AND INSTALL HIGH PRESSURE FUEL

John Deere — REMOVE AND INSTALL HIGH PRESSURE FUEL

A John Deere service procedure — check it applies to your exact model before use.

Browse John Deere generators & specs →

Before you start

  • NOTE: Keep foreign material free from replacement

Procedure

  1. 2. Cap delivery valve holders on pump to prevent
  2. entering of foreign material.
  3. 3. Clean housing surface around inlet filter plug.
  4. 4. Remove inlet filter plug (A) and filter using a hexagonal
  5. wrench.
  6. NOTE: Keep foreign material free from replacement
  7. components.
  8. 5. Install new filter, o-ring, plug, and gasket. Tighen plug
  9. to specification.
  10. Specification
  11. High Pressure Fuel Pump Inlet
  12. Filter Plug—Torque
  13. 18 N•m (13.3 lb-ft)
  14. ......................................................
  15. 6. Install high pressure fuel pump. See REMOVE AND

Tools required

  • wrench.

Specs & torque values

  • 13.3 lb-ft

Source: manual:CTM220.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.