Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›3. Install high pressure pump. Align timing mark (B) on

John Deere — 3. Install high pressure pump. Align timing mark (B) on

A John Deere service procedure — check it applies to your exact model before use.

Browse John Deere generators & specs →

Before you start

  • NOTE: Keep foreign material free from replacement
  • NOTE: It might be helpful to number the lines per cylinder

Procedure

  1. 4. Install high pressure fuel lines (C) between High
  2. Pressure Common Rail and High Pressure Pump.
  3. Torque fittings to specification.
  4. Specification
  5. High Pressure Fuel Lines -
  6. Injection Pump Fitting—Torque
  7. 27 N•m (19.9 lb-ft)
  8. ....................................
  9. High Pressure Fuel Lines - High
  10. Pressure Common Rail Fitting—
  11. Torque
  12. 27 N•m (19.9 lb-ft)
  13. ..........................................................................
  14. 5. Install high pressure fuel pump leak off line (D). Torque
  15. to specification.
  16. Specification
  17. High Pressure Fuel Pump
  18. Leak-off Line Fitting—Torque
  19. 6 N•m (4.4 lb-ft)
  20. ...........................................

Tools required

  • wrench.

Specs & torque values

  • 4.4 lb-ft
  • 19.9 lb-ft
  • 6.6 lb-ft

Source: manual:CTM220.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.