John Deere 9.0 L Diesel Engines — Changing Top-Load Oil Filter
Maintenance · Top-load oil filter assembly
For the John Deere 9.0 L Diesel Engines, from the John Deere service manual.
Applies to: John Deere 6090H engine
Parts for this job
- RE538245 Oil filter Amazon eBay $39.99 NAPA $33.32 KuduParts $16.00
Part numbers from the service-parts list for John Deere 6090H engine. Verify against your serial number before ordering; some links are affiliate links.
Procedure
- Use a wrench to unscrew cap; wait 30 seconds to allow oil filter housing to drain.
- Remove cap and filter assembly.
- While holding on to screw cap, strike filter element against a solid surface to disconnect filter from cap; discard used filter.
- Remove o-ring seal and replace with new o-ring provided with new filter element.
- Press new filter into cap until it snaps into place.
- Insert cap and filter assembly into oil filter housing; screw cap in place.
- Use wrench to tighten cap to specification.
Tools required
- wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Top-Load Oil Filter Cap 40—50 N·m (30—37 lb-ft)
Full service-parts list: John Deere 6090H engine →
Source: John Deere service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.