John Deere 6101 — Install Water Pump - 6101AT001 Engines
Installation · Cooling system
For the John Deere 6101, from the John Deere service manual.
Applies to: John Deere 6101
Before you start
- Air must be expelled from cooling system when refilling
Procedure
- Install water pump onto cylinder block with a new gasket.
- Tighten four mounting cap screws to 68 N·m (50 lb-ft).
- Install oil cooler-to-water pump hose and tighten clamp securely.
- Install bypass hose on pump elbow and tighten clamp.
- Install aftercooler inlet hose and tighten clamp.
- Connect coolant filter conditioner line using new packing.
- Install fan and fan belts; adjust belt tension.
- Install washer and cap screw on pump shaft; tighten to 115 N·m (85 lb-ft).
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Water pump-to-cylinder block 68 N·m (50 lb-ft)
- Fan pulley-to-water pump shaft 115 N·m (85 lb-ft)
Full service-parts list: John Deere 6101 →
Source: John Deere service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.