John Deere 6101 — Install Cylinder Head
Installation
For the John Deere 6101, from the John Deere service manual.
Applies to: John Deere 6101
Before you start
- Do not use screwdrivers or pry bars between block and head
Procedure
- Place a new head gasket on cylinder block; do not use sealant.
- Position cylinder head over dowels using appropriate lifting equipment.
- Clean cap screws; dip entire cap screws and washers in clean engine oil.
- Install cap screws in proper locations (197, 171, 248 mm lengths).
- Tighten cap screw No. 17 to 200 N·m (150 lb-ft) first.
- Tighten remaining cap screws to 200 N·m in numerical sequence.
- Torque-turn all cap screws 90-100 degrees in same sequence.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Initial 200 N·m (150 lb-ft)
- Final tighten additional 90-100 degrees
Full service-parts list: John Deere 6101 →
Source: John Deere service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.