John Deere 4045 / 6068 — Stopping The Engine
Operation
For the John Deere 4045 / 6068, from the John Deere operator's manual.
Applies to: John Deere 4045, John Deere 6068
Before you start
- Make sure exhaust stack rain cap is installed when engine is not running.
Procedure
- Disengage clutch, if equipped, controlling engine power driveline.
- Run engine at 1000—1200 rpm for at least 2 minutes to cool.
- Set High-Low Speed Select Rocker Switch or Analog Throttle to low idle.
- Push in analog throttle potentiometer handle if equipped.
- Turn key switch to OFF position to stop the engine. Remove ignition key.
Specs & values
- Idle engine at least 2 minutes at 1000—1200 rpm before stopping after working load
Full service-parts list: John Deere 4045 →, John Deere 6068 →
Source: John Deere operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.