John Deere 4045 / 6068 — Replace Final Fuel Filter Element
Maintenance
For the John Deere 4045 / 6068, from the John Deere service manual.
Applies to: John Deere 4045, John Deere 6068
Before you start
- Do not overtighten the retaining ring.
Procedure
- Clean fuel filter/water bowl assembly and surrounding area.
- Connect a fuel line to filter drain adapter and drain all fuel.
- Loosen retaining ring 1/4 turn; remove retaining ring with filter element and water bowl.
- Inspect filter mounting base; clean as required.
- Remove water bowl if equipped; drain, clean and dry with compressed air.
- Install water bowl onto new filter element.
- Inspect filter base seal ring; replace as needed.
- Install new filter element, indexing the key in the base slot.
- Install retaining ring and tighten about 1/3 turn until it snaps into detent.
- Bleed fuel system.
- If applicable, connect water in fuel sensor connector.
Full service-parts list: John Deere 4045 →, John Deere 6068 →
Source: John Deere service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.