Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›4. Remove filter element using suitable filter wrench.

John Deere — 4. Remove filter element using suitable filter wrench.

A John Deere service procedure — check it applies to your exact model before use.

Browse John Deere generators & specs →

Procedure

  1. 5. Disconnect fuel lines from inlet (A) and outlet (B) ports.
  2. 6. Disconnect fuel line fitting (C) from pressure relief valve.
  3. 7. Remove 2 capscrews (D) from filter head and remove head from mounting bracket on engine. Install Fuel Filter Head
  4. 1. Loosely install filter head to filter mounting bracket. Do not tighten cap screws.
  5. 2. Loosely connect fuel lines to fuel filter inlet and outlet ports. Do not tighten.
  6. 3. Tighten filter head to mounting bracket on engine to specification.

Source: manual:CTM255.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.