John Deere 210 — Replace brake band
Repair & overhaul · Brakes
For the John Deere 210, from the John Deere service manual.
Applies to: John Deere 210
Procedure
- Remove cotter pin and drilled pin from brake arm.
- Remove left rear wheel.
- Remove two cap screws through access holes.
- Slip brake band off brake pulley.
- Install new brake band and reverse disassembly.
- Adjust brake linkage.
Tools required
- socket and extension Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: John Deere 210 →
Source: John Deere service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.