Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›10. Remove and dispose of filler cup.

John Deere — 10. Remove and dispose of filler cup.

A John Deere service procedure — check it applies to your exact model before use.

Browse John Deere generators & specs →

Procedure

  1. 11. Lubricate packing (F) (on previous page) and install filter onto base. Tighten 3/4 turn after packing contacts base. Connect sensor.
  2. 12. Start and run engine at fast idle for 2 minutes. If engine won’t start or dies, bleed the fuel system. See

Source: manual:CTM255.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.