Iveco/FPT — Replacement of the solenoid valve throttle
Repair & overhaul · Stanadyne injection pump solenoid valve throttle
From a Iveco/FPT service manual covering: GE NEF 100M, GE NEF 125M, GE NEF 130M, GE NEF 160M, GE NEF 200E, GE NEF 45M, GE NEF 60M, GE NEF 75M, GE NEF 85M, GS NEF 100M, GS NEF 125M, GS NEF 130M…. Check it applies to your exact model before use.
Applies to: Iveco/FPT GE NEF 100M, Iveco/FPT GE NEF 125M, Iveco/FPT GE NEF 130M, Iveco/FPT GE NEF 160M, Iveco/FPT GE NEF 200E, Iveco/FPT GE NEF 45M, Iveco/FPT GE NEF 60M, Iveco/FPT GE NEF 75M, Iveco/FPT GE NEF 85M, Iveco/FPT GS NEF 100M, Iveco/FPT GS NEF 125M, Iveco/FPT GS NEF 130M
Before you start
- Electro-valve and solenoid valve throttle on same injection pump must have the same operating voltage; if voltage changes both must be replaced.
Procedure
- Disconnect linkage connector from temperature sensor on motor.
- Remove fixing nut of socket clamp and nut of cable group end.
- Remove fixing nut from magnet and remove component from its seat.
- Insert connection cable socket in cable group end and screw nut.
- Position socket clamp and screw fixing nut.
- Position magnet in its seat and screw self-blocking fixing nut supplied with kit.
Specs & values
- Connection cable socket nut 5,7 ÷ 6,8 Nm
- Socket clamp fixing nut 7,9 ÷ 9,0 Nm
- Magnet self-blocking fixing nut 5,1 ÷ 5,7 Nm
Source: Iveco/FPT service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.