Iveco/FPT — Oil motor and filter replacement
Maintenance · Engine oil and oil filter
From a Iveco/FPT service manual covering: GE NEF 100M, GE NEF 125M, GE NEF 130M, GE NEF 160M, GE NEF 200E, GE NEF 45M, GE NEF 60M, GE NEF 75M, GE NEF 85M, GS NEF 100M, GS NEF 125M, GS NEF 130M…. Check it applies to your exact model before use.
Applies to: Iveco/FPT GE NEF 100M, Iveco/FPT GE NEF 125M, Iveco/FPT GE NEF 130M, Iveco/FPT GE NEF 160M, Iveco/FPT GE NEF 200E, Iveco/FPT GE NEF 45M, Iveco/FPT GE NEF 60M, Iveco/FPT GE NEF 75M, Iveco/FPT GE NEF 85M, Iveco/FPT GS NEF 100M, Iveco/FPT GS NEF 125M, Iveco/FPT GS NEF 130M
Before you start
- Wear protection gloves because of high motor service temperature.
- Oil filter contains about 1 kg of engine oil; place a proper container.
Procedure
- Place container for oil under the pan connected with drain plug.
- Unscrew plug, take out dipstick and inserting plug to ease downflow.
- After complete drainage screw plug and carry out clean oil filling.
- Check level through dipstick up to maximum level notch.
- Replace filtering cartridge using 99360076 tool; screw manually until gasket contacts support.
- Tighten by means of 99360076 tool of three fourth turn.
- Operate motor some minutes and check level again, topping up if necessary.
Tools required
- 99360076 Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Oil filter tightened 3/4 turn after gasket contact
Source: Iveco/FPT service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.