Home›Repair guides›Iveco/FPT›Replace fuel sedimentation tank prefilter

Iveco/FPT C13 — Replace fuel sedimentation tank prefilter

Maintenance · Fuel prefilter

For the Iveco/FPT C13, from the Iveco/FPT service manual.

Applies to: Iveco/FPT C13

Before you start

  • Filter cartridge must not be prefilled to prevent circulating dirt damaging injector/pump components

Procedure

  1. Disconnect electric connector.
  2. Unlock prefilter and change it.
  3. Before refitting a new cartridge, wet the seal with fuel oil or engine oil.
  4. Lock cartridge by hand until in contact with support, then lock by 3/4 of a rev. at predefined tightening torque.
  5. Bleed air from fuel filter.

Source: Iveco/FPT service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Iveco/FPT repair guides →