Iveco/FPT C13 — Fitting engine flywheel
Repair & overhaul
For the Iveco/FPT C13, from the Iveco/FPT service manual.
Applies to: Iveco/FPT C13
Before you start
- Ring gear must be fitted after heating to approx. 200 degrees C
Procedure
- Position the flywheel on the crankshaft, lubricating the screw threads with engine oil.
- Lock rotation with tool 99360351.
- First phase: pre-tighten screws to 100 Nm (10 kgm).
- Second phase: close to 60 degrees angle with tool 99395216.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- 100 Nm pre-tightening
- 60 degrees angle closing
Source: Iveco/FPT service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.